This is the final-ish Boxcutter for Blender 2.79+.
It is recommended to update to the latest build via the buildbot. Users have reported issues with 2.79B. If you are having issues with 3d box crashing please try updating Blender. This has been found to resolve most of the issues.
The next update will be for 2.8.
Boxcutter has had a few small changes and improvements mainly bugfixes.
The D menu has been adjusted and a new workflow mode for Destructive and Non-Destructive is in the pie menu.
Destructive
Behaves as classic in red box 2d/3d. Just cuts and is done.
Yellow box is also connected to desctuctive / non destructive.
Non-Destructive
Booleans are kept as modifiers if shift is not held.
Yellow box also has a non-destructive counterpart.
Grey Box Deselect
This one was requested by Jama.
Grey box deselect will auto deselect the grey box allowing for rapid grey box creation.
I can’t wait to see what is done with it.
Autosmooth
For those who use Boxcutter without Hard Ops >> SSharpen. Boxcutter now sets autosmooth for those who cut the greys. Just better shading.
There are many additional bugfixes in addition to small enhancements.
- NGON doubleclick error
- HOPS not present error
-
dead boolean error resolved
-
boolean naming convention
-
low level boolean application
-
local mode fixes
-
3d box improvements
-
hops integration matcut improvements
We hope you continue to enjoy Boxcutter and report any support issues to my email (masterxeon1001@gmail.com).
From Imagination To Creation 
[…] information about Boxcutter and Hard Ops here. Boxcutter 6.9.0 : Poly Dirk […]
Hi, I have an issue with grid size, no matter what size is set, the grid stays the same, what I’m doing wrong?
well if youre using the custom it can be scaled. shift + MMB. Default uses the blender grid.
Just purchased your 38$ bundle boxcutter and there is an error saying I need to upgrade to 2.8 but I have the newest release of blender. What’s going on here?
https://hardops-manual.readthedocs.io/en/latest/faq/#help-i-just-installed-and-it-says-i-need-to-upgrade
Hi, I work with Blender 2.76 with a PC Linux 32bit arch. and so I need the old version of Boxcutter like 6.9.0, right? If so, I can’t find it, there is a link for this old version? They don’t know to tell me in Blender Market either. Thank you for replay